Stationary Journal Machining
As part of our onsite capabilities, CFS offers Stationary Journal Machining that can be provided when rotating the shaft is not possible or would be cost prohibitive. With an impressive stock-removal rate per pass and a surface finish of 32 RMS or better, our machine is one of the very best in the industry.
More Services
24 Hour
Emergency Service
1.800.627.6885
Job Samples
This dam project consisted of remachining the face of a 108″ lower flange and boring holes in an upper flange. Total project time was 7 days, mobilization to demobilization. All equipment used was manufactured by CFS.
This MSIV project consisted of both the inboard and outboard sets of MSIV’s for a total of 8 valves. Work on each valve varied from just mapping, skimming and honing, to a full guide rib repair. Although this project did not consist of a seat repair, it is fully within our realm expertise. read more…
The work scope of this repair included skim cutting two seal faces, machining out two studs from the suction end, and a weld repair and machining of the stuffing box face and bore. read more…
Our Customers Say It Best
Excellent work – very professional. No Complaints at all!
Excellent workmanship and diligence toward project goal and deadline.
Greater Chattanooga, Tennessee
CFS employees responded quickly to our emergent needs and provided a quality service. You are fortunate to have employees who perform at such a high level. Mr. Jackson represented your company well